[Prusa I3][3PD] How to upload firmware to (Mega 2560)

1. Download Arduino 1.0.5
Open the Marlin.ino


2. Compile the code
Choose Board Type : Tools –> Board –> Arduino MEGA 2560


Start to compile


3. Change to the location of arduino firmware.
/tmp/build2709516825013937380.tmp

4. Upload firmware to the board
Method 1:
Execute
sudo avrdude -p m2560 -c stk500v2 -b 115200 -P/dev/ttyUSB0 -U flash:w:Marlin.cpp.hex:i -D

[happy@localhost build4709796185245500912.tmp]$ sudo avrdude  -p m2560 -c stk500v2 -b 115200 -P/dev/ttyUSB0 -U flash:w:Marlin.cpp.hex:i -D

avrdude: AVR device initialized and ready to accept instructions

Reading | ################################################## | 100% 0.01s

avrdude: Device signature = 0x1e9801
avrdude: reading input file "Marlin.cpp.hex"
avrdude: writing flash (116672 bytes):

Writing | ################################################## | 100% 17.43s

avrdude: 116672 bytes of flash written
avrdude: verifying flash memory against Marlin.cpp.hex:
avrdude: load data flash data from input file Marlin.cpp.hex:
avrdude: input file Marlin.cpp.hex contains 116672 bytes
avrdude: reading on-chip flash data:

Reading | ################################################## | 100% 13.54s

avrdude: verifying ...
avrdude: 116672 bytes of flash verified

avrdude: safemode: Fuses OK (E:FF, H:D8, L:FF)

avrdude done.  Thank you.

Method 2:
Using arduino GUI to upload the file.


Reference:

• Example Command Line Invocations
Prusa i3 Rework Firmware